Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2005 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 35 (Wiper System & Washer System) >> Repair Instructions >> Hose Replacement - Windshield Washer >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the washer hose to the vehicle.
  2. Route the washer pump hose down along side the right front inner fender and into the front inner fender area.
  3. Connect the washer hose to the air inlet grille panel.
    4. Fig 1: Connecting Washer Hose To Air Inlet Grille Panel
    GM815215Courtesy of GENERAL MOTORS CORP.
  4. Connect the washer hose to the wiper arms.
    5. Fig 2: Connecting Washer Hose To Wiper Arms
    GM815210Courtesy of GENERAL MOTORS CORP.
  5. Raise the vehicle.
  6. Connect the washer hose to the washer pump.
    7. Fig 3: Connecting Washer Hose To Washer Pump
    GM815217Courtesy of GENERAL MOTORS CORP.
  7. Install the right front fender liner. Refer to Front Fender Liner Replacement in Body Front End.
  8. Close the hood.
scientia non olet · About Mike's Workshop Manuals