Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2005 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Engine Control System 3.4L (Introduction)) >> Repair Instructions >> Fuel Pressure Gage Installation and Removal >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place the fuel pressure gage bleed hose into an approved container and open the bleed valve to bleed fuel system pressure.
  2. Place a shop towel under the fuel pressure gage adaptor fitting to catch any remaining fuel spillage.
  3. Remove J 34730-1A  from the adaptor fitting. See Special Tools and Equipment .
  4. Remove J 34730-262  . See Special Tools and Equipment .
    5. Fig 1: Removing J34730-1A From Fuel Rail
    GM736294Courtesy of GENERAL MOTORS CORP.
  5. Drain any fuel remaining in the fuel pressure gage into an approved container.
  6. Install the cap on the fuel pressure connection.
scientia non olet · About Mike's Workshop Manuals