Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2005 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Engine Control System 3.4L (Introduction)) >> Repair Instructions >> Crankshaft Position (CKP) Sensor Replacement (7X) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the steering wheel fully to the left.
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  3. Remove the right front wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  4. Disconnect the crankshaft position (CKP) sensor electrical connector.
  5. Remove the CKP sensor bolt.
  6. Remove the CKP sensor.
  7. Inspect for wear, cracks, or leakage if the sensor is not being replaced.
    8. Fig 1: View Of CKP Sensor (7X)
    GM15969Courtesy of GENERAL MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals