Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2005 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (Antilock Brake System And Traction Control System) >> Repair Instructions >> Brake Pressure Modulator Valve (BPMV) Bracket Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the Ignition switch to the OFF position.
  2. Remove the 2 BPMV mounting bracket nuts (3) and one bolt located near the bottom and one nut (1) located at the top of the BPMV mounting bracket (4) to the strut tower.
  3. Disconnect the ground strap between the EBCM assembly and the chassis.
  4. Remove the BPMV mounting bracket (4) from the vehicle.
  5. Remove BPMV and EBCM assembly (2) from the BPMV mounting bracket (4).
    6. Fig 1: Removing BPMV Mounting Bracket
    GM394422Courtesy of GENERAL MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals