Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2005 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 140 (Engine Controls - 3.6L - Introduction) >> Repair Instructions >> Barometric Pressure (BARO) Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Barometric Pressure (BARO) Sensor & Bolt
    GM1395942Courtesy of GENERAL MOTORS CORP.
  1. Install the barometric pressure sensor.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the barometric pressure sensor bolt.

    Tighten:  Tighten the barometric pressure sensor bolt to 10 N.m (89 lb in).

    3. Fig 2: View Of Barometric Pressure (BARO) Sensor Electrical Connector
    GM1401472Courtesy of GENERAL MOTORS CORP.
  3. Install the sensor electrical connector.
scientia non olet · About Mike's Workshop Manuals