Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2005 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Entertainment System) >> Repair Instructions >> Coaxial Cable Replacement - Digital Radio >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the antenna cable retainers to the receiver bracket.
  2. Connect the antenna cable to the digital radio receiver.
  3. Attach the wire or string used in the removal procedure to the cable being installed.
  4. Carefully pull the antenna cable through the rear shelf into the passenger compartment.
  5. Install the right rear compartment trim panel.
  6. Remove the wire or string from the antenna cable.
  7. Route the antenna cable between the dome lamp harness and the upper quarter panel.
  8. Fig 1: Routing Antenna Cable
    GM859172Courtesy of GENERAL MOTORS CORP.
  9. Install the antenna cable to the dome lamp harness clips.
  10. Install the antenna cable retainer (3) to the rear header (2).
  11. Connect the antenna cable to the antenna base cable connector.
  12. Fig 2: Installing Antenna Cable
    GM859171Courtesy of GENERAL MOTORS CORP.
  13. Install the antenna cable mastic patch/tape at the roof.
  14. Install the rear of the headliner. Refer to Headliner Replacement (Impala) or Headliner Replacement (Monte Carlo) in Interior Trim.
  15. Install the right rear upper quarter trim panel. Refer to Trim Panel Replacement - Rear Quarter Upper (Impala) or Trim Panel Replacement - Rear Quarter Upper (Monte Carlo) in Interior Trim.