Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2004 >> Vibe Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Control System (Introduction) -- 1.8L (LNK)) >> Repair Instructions >> Secondary AIR Injection Pressure Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Electrical Connector, AIR Pressure Sensor, Shut Off Valve And Fastener
    GM1287604Courtesy of GENERAL MOTORS CORP.
  1. Install the secondary AIR pressure sensor (2) to the shut off valve (3) with the one fastener (4).
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Tighten the secondary AIR pressure sensor fastener (4).

    Tighten:  Tighten the fastener to 8.8 N.m (77 lb in).

  3. Connect the electrical connector (1) to the AIR pressure sensor (2).


    Fig 1: Electrical Connector, Air Pressure Sensor And Shut Off Valve
    GM1467195Courtesy of GENERAL MOTORS CORP.
  1. Install the secondary AIR pressure sensor (2) to the shut off valve (3).
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Secure the secondary AIR pressure sensor with two fasteners.

    Tighten:  Tighten the fasteners to 5.0 N.m (44 lb in).

  3. Connect the electrical connector (1) to the AIR pressure sensor (2).
scientia non olet · About Mike's Workshop Manuals