Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2004 >> Vibe Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Control System (Introduction) -- 1.8L (LNK)) >> Repair Instructions >> Intake Air Temperature (IAT) Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Electrical Connector, Air Cleaner Housing, Mass Air Flow (Maf) Sensor And O-Ring
    GM828876Courtesy of GENERAL MOTORS CORP.
  1. Install a new O-ring (3) on the MAF sensor.
  2. Install the MAF sensor (4) into the air cleaner housing (2).
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Secure the MAF sensor to the air cleaner housing with the 2 fasteners.

    Tighten:  Tighten the 2 fasteners to 2 N.m (18 lb in).

  4. Connect the MAF sensor electrical connector (1).
scientia non olet · About Mike's Workshop Manuals