Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2004 >> Vibe Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 129 (Engine Control System - 1.8L (LNK) - Introduction) >> Repair Instructions >> Throttle Position (TP) Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Throttle Body, TP Sensor And Throttle Shaft
    GM850215Courtesy of GENERAL MOTORS CORP.
  1. Align the throttle shaft (3) with the slot in the TP sensor (2).
  2. Install the TP sensor (2) to the throttle body (1).
    3. Fig 2: View Of TP Sensor Components
    GM229615Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Secure the TP sensor with the 2 fasteners (3).

    Tighten:  Tighten the fasteners to 2.0 N.m (18 lb in).

  4. Install the inlet air duct to the air cleaner and the throttle body.
scientia non olet · About Mike's Workshop Manuals