Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2004 >> Vibe Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 121 (Antilock Brake System, Traction Control System & Stability Control System) >> Repair Instructions >> Wheel Speed Sensor Replacement - Rear (FWD) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Wheel Speed Sensor To Rear Wheel Hub
    GM840296Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the wheel speed sensor to rear wheel hub.
  2. Install the rear axle hub and bearing assembly. Refer to Wheel Bearing/Hub Replacement - Rear (FWD) or Wheel Bearing/Hub Replacement - Rear (AWD) in Rear Suspension.
    3. Fig 2: Wheel Cylinder Components
    GM829894Courtesy of GENERAL MOTORS CORP.
  3. Connect the wheel speed sensor electrical connector (6).
  4. Perform Diagnostic System Check - Vehicle in Vehicle DTC Information.
scientia non olet · About Mike's Workshop Manuals