Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2004 >> Vibe Base, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System (Introduction) - 1.8L (LV6) >> Repair Instructions >> Crankshaft Position (CKP) Sensor Replacement >> Removal Procedure

Removal Procedure

  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
    2. Fig 1: Stone Shield, Bolts And Retainers
    GM830841Courtesy of GENERAL MOTORS CORP.
  2. Remove the two bolts (3) that secure the stone shield (1).
  3. Remove the four retainers (2) and the stone shield (1).
    4. Fig 2: CKP Sensor And Hold Down Bolt
    GM181701Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the CKP sensor electrical connector.
  5. Remove the one hold down bolt (2).
  6. Remove the CKP sensor (1) from the front cover of the engine block.
scientia non olet · About Mike's Workshop Manuals