Test Description
The numbers below refer to the step numbers on the diagnostic table.
- 2: Checks to see if other DTC is set.
- 3: Checks to see if steering angle sensor is centered.
DTC C0253
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: ABS Schematics Connector End View Reference: ABS Connector End Views |
|||
| 1 | Did you perform the ABS Diagnostic System Check? | Go to Step 2 | Go to Diagnostic System Check - ABS |
| 2 |
|
Go to Diagnostic Trouble Code (DTC) List | Go to Step 3 |
| 3 | Perform the steering angle sensor centering procedure. Refer to Steering Angle Sensor Centering Procedure . Did you successfully complete the centering procedure? |
Go to Step 4 | Go to Step 5 |
| 4 |
|
Go to Step 6 | Go to Diagnostic Aids |
| 5 | Replace the steering angle sensor. Refer to Steering Wheel Position Sensor or Steering Shaft Lower Bearing Replacement
in Steering Wheel and Column. Did you complete the replacement? |
Go to Step 7 | - |
| 6 | Replace the EBCM. Refer to Electronic Brake Control Module Replacement . Did you complete the replacement? |
Go to Step 7 | - |
| 7 |
|
Go to Step 2 | System OK |