Test Description
The numbers below refer to step numbers on the diagnostic table.
- 2: Checks if the IPC has the ability to turn the ABS Indicator on.
ABS Indicator Inoperative
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: ABS Schematics | |||
| 1 | Did you perform the ABS Diagnostic System Check? | Go to Step 2 | Go to Diagnostic System Check - ABS |
| 2 | Using a scan tool in the Instrument Panel (IPC) Special Functions attempt to turn the ABS indicator on. Did the ABS indicator turn on? |
Go to Step 3 | Go to Step 4 |
| 3 | Replace the EBCM. Refer to Electronic Brake Control Module Replacement . Is the replacement complete? |
Go to Step 7 | - |
| 4 |
|
Go to Step 6 | Go to Step 5 |
| 5 | Repair the instrument clusters connectorsRepairing Connector Terminals
in Instrument Panel, Gages and Console. Is the repair complete? |
Go to Step 7 | - |
| 6 | Replace the Instrument Panel Cluster. Refer to Instrument Panel Cluster (IPC) Replacement
in Wiring Systems. Is the replacement complete? |
Go to Step 7 | - |
| 7 | Operate the system in order to verify the repair. Did you correct the condition? |
System OK | Go to Step 2 |