Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2004 >> Bonneville GXP >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls (Introduction) -- 4.6L (LD8) >> Repair Instructions >> Manifold Absolute Pressure (MAP) Sensor Replacement >> Installation Procedure

Installation Procedure

    Fig 1: MAP, IAC, ECT, TP Sensors
    GM602335Courtesy of GENERAL MOTORS CORP.
  1. Install the MAP sensor (1) into the intake manifold.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the throttle cable bracket and bolts.

    Tighten:  Tighten the bracket bolts to 12 N.m (106 lb in).

  3. Connect the MAP sensor electrical connector.
scientia non olet · About Mike's Workshop Manuals