Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2004 >> Aztek Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 200 (Engine Control System 3.8L (Introduction)) >> Repair Instructions >> Manifold Absolute Pressure (MAP) Sensor Replacement (L36) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement in Engine Mechanical 3.8L.
  2. Disconnect the MAP sensor electrical connector.
  3. Carefully release the locking tabs holding the MAP (1) sensor to the PCV valve cover (2) just enough to remove the MAP sensor.
  4. Pull the MAP sensor straight out of PCV valve cover.
    5. Fig 1: Removing MAP Sensor (L36)
    GM12346Courtesy of GENERAL MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals