Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2004 >> Aztek Base, AWD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle - 4T65-E (Introduction, Service & Replacement) >> Repair Instructions >> Torque Converter Cover Replacement (LY7) >> Installation Procedure

Installation Procedure

    Fig 1: Locating Torque Converter Cover Bolts (LY7)
    GM1409587Courtesy of GENERAL MOTORS CORP.
  1. Install the torque converter cover.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the torque converter cover bolts.

    Tighten:  Tighten the bolts to 8 N.m (71 lb in).

  3. Lower the vehicle.
scientia non olet · About Mike's Workshop Manuals