Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2004 >> Aztek Base, AWD >> Repair and Diagnosis >> Restraints >> Restraints Control Systems >> Seat Belt System >> Repair Instructions >> Seat Belt Retractor Replacement - Left Front (Pontiac) >> Installation Procedure

Installation Procedure

    Fig 1: Removing/Installing Seat Belt Retractor
    GM620833Courtesy of GENERAL MOTORS CORP.
  1. Install the seat belt retractor to the center pillar.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 2: View Of Seat Belt Retractor Bolt
    GM620831Courtesy of GENERAL MOTORS CORP.
  2. Install the bolt to the seat belt retractor.

    Tighten:  Tighten the seat belt retractor bolt to 42 N.m (31 lb ft).

  3. Install the center pillar lower trim. Refer to Trim Panel Replacement - Lower Center Pillar in Interior Trim.
    4. Fig 3: Locating Seat Belt Guide Loop
    GM620836Courtesy of GENERAL MOTORS CORP.
  4. Place the seat belt guide loop to the guide adjuster bracket.
    5. Fig 4: View Of Seat Belt Guide Loop Nut
    GM620834Courtesy of GENERAL MOTORS CORP.
  5. Install the nut to the seat belt guide loop.

    Tighten:  Tighten the seat belt guide loop nut to 42 N.m (31 lb ft).

  6. Install the seat belt guide loop cover.
    7. Fig 5: View Of Front Seat Belt Anchor
    GM620838Courtesy of GENERAL MOTORS CORP.
  7. Place the front seat belt anchor plate to the front seat rear outboard stud.
  8. Install the front bucket seat. Refer to Seat Replacement - Bucket in Seats.
scientia non olet · About Mike's Workshop Manuals