Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2004 >> Aztek Base, AWD >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Heating, Ventilation And Air Conditioning >> Repair Instructions >> Receiver Dehydrator Replacement >> Installation Procedure

Installation Procedure

  1. If replacing the receiver dehydrator, add the specified amount of PAG oil directly to the receiver dehydrator. Refer to Refrigerant System Capacities .
  2. Install new sealing washers to the receiver dehydrator.
    3. Fig 1: View Of Receiver Dehydrator Upper Bracket Bolt
    GM887653Courtesy of GENERAL MOTORS CORP.
  3. Connect the receiver dehydrator to the condenser. Refer to Sealing Washer Replacement .
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the receiver dehydrator lower mounting bolts.

    Tighten:  Tighten the bolts to 6 N.m (53 lb in).

  5. Install the receiver dehydrator upper bracket bolt.

    Tighten:  Tighten the bolt to 6 N.m (53 lb in).

  6. Install the condenser. Refer to Condenser Replacement .
  7. Evacuate and recharge the A/C system. Refer to Refrigerant Recovery and Recharging .
  8. Leak test the fittings of the component using J 39400-A  .
scientia non olet · About Mike's Workshop Manuals