Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2004 >> Aztek Base, AWD >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Heating, Ventilation And Air Conditioning >> Repair Instructions >> Compressor Relay Replacement >> Removal Procedure

Removal Procedure

  1. Remove the electrical center cover.
  2. Locate the compressor relay. Refer to Electrical Center Identification Views to locate the electrical center where the compressor relay exists.
    3. IMPORTANT:
    • Always note the orientation of the relay.
    • Make sure the electrical center is secure, as not to put added stress on the wires or terminals.
    Fig 1: Removing/Installing Relay Using J 43244
    GM786629Courtesy of GENERAL MOTORS CORP.
  3. Using the J 43244  (1) position the tool on opposing corners of the compressor relay (2).
    4. NOTE: Use J43244 to pull the relay straight out from the electrical center terminals. The use of pliers or a flat bladed tool could damage the electrical center.
  4. Remove the compressor relay (2) from the electrical center.
scientia non olet · About Mike's Workshop Manuals