Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2004 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 60 (Steering Wheel And Steering Column) >> Repair Instructions >> Multifunction, Turn Signal Switch Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the upper and lower steering column trim covers. Refer to STEERING COLUMN TRIM COVERS REPLACEMENT (TELESCOPING)  or STEERING COLUMN TRIM COVERS REPLACEMENT (MANUAL)  .
    Fig 1: Removing Lower Steering Column Trim Cover
    G01419171Courtesy of GENERAL MOTORS CORP.
  2. Remove the wire harness straps (2) from the steering column tilt head assembly (1) and the column.
    Fig 2: Removing Wire Harness Straps From Steering Column Tilt Head Assembly
    G01419172Courtesy of GENERAL MOTORS CORP.
  3. Remove the wire harness assembly (1) from the wire harness strap (2).
    Fig 3: Removing Wire Harness Assembly From Wire Harness Strap
    G01419173Courtesy of GENERAL MOTORS CORP.
  4. Remove the 2 pan head tapping screws (1).
    Fig 4: Removing Pan Head Tapping Screws
    G01419174Courtesy of GENERAL MOTORS CORP.
  5. Remove the multifunction turn signal switch assembly (1).
    Fig 5: Removing Multifunction Turn Signal Switch Assembly
    G01419175Courtesy of GENERAL MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals