Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2004 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 334 (Instrument Panel System Displays, Gauges And Console) >> Repair Instructions >> Driver Information Center Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: DIC Switch To I/P Cluster Bezel
    GM95723Courtesy of GENERAL MOTORS CORP.
  1. Install the DIC switch to the IP cluster bezel.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the DIC switch retaining screws.

    Tighten:  Tighten the DIC switch retaining screws to 1.5 N.m (13 lb in).

    3. Fig 2: IP Cluster Bezel To IPC
    GM95724Courtesy of GENERAL MOTORS CORP.
  3. Install the bezel to the IPC.

    Align the bezel onto the guide pins.

  4. Install the IP cluster bezel retaining screws.

    Tighten:  Tighten the IP cluster bezel retaining screws to 1.5 N.m (13 lb in).

    5. Fig 3: Instrument Panel Dimmer/HUD Switch Electrical Connector
    GM95725Courtesy of GENERAL MOTORS CORP.
  5. Connect the IP dimmer switch or the IP dimmer/HUD switch electrical connector.
    6. Fig 4: Driver Information Center (DIC) Switch Electrical Connector
    GM95726Courtesy of GENERAL MOTORS CORP.
  6. Connect the DIC switch electrical connector.
  7. Install the IPC to the vehicle. Refer to Instrument Panel Cluster (IPC) Replacement .
scientia non olet · About Mike's Workshop Manuals