Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2004 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 261 (Lighting Systems) >> Repair Instructions >> Park/Turn Signal Lamp Bulb Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the electrical connector to the park/turn lamp bulb/socket.
    2. Fig 1: Electrical Connector & Fog Lamp Bulb/Socket
    GM812125Courtesy of GENERAL MOTORS CORP.
  2. Install the park/turn lamp bulb/socket to the fog lamp, turning clockwise, if required.
    3. Fig 2: Fog Lamp & Front Bumper Fascia
    GM1228603Courtesy of GENERAL MOTORS CORP.
  3. Position the fog lamp to the front bumper fascia.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the front fog lamp screws to the fog lamp.

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

    5. Fig 3: Front Fog Lamp Screws
    GM1228602Courtesy of GENERAL MOTORS CORP.
  5. Inspect and adjust the front fog lamp aim as necessary. Refer to Fog Lamp Aiming Procedure .
scientia non olet · About Mike's Workshop Manuals