Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.

Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
Drill out the plastic rivits from the front bumper fascia extension corner to the front fender liner.

Fig 1: Front Bumper Fascia Extension Plastic Rivets

Courtesy of GENERAL MOTORS CORP.

Remove the lower fascia support. Refer toFascia Support Replacement - Front Bumper Lower (Impala) or Fascia Support Replacement - Front Bumper Lower (Monte Carlo) in Bumpers.
Remove the front fender liner to front bumper fascia screws.

Fig 2: Front Fender Liner To Front Bumper Fascia Screws

Courtesy of GENERAL MOTORS CORP.

Remove the spring clips from the fascia extension.

Fig 3: Fascia Extension Spring Clips

Courtesy of GENERAL MOTORS CORP.

Remove the fascia extension.

Fig 4: Fascia Extension

Courtesy of GENERAL MOTORS CORP.