Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2004 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 212 (Body Front End) >> Repair Instructions >> Hood Latch Release Handle Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the hood release cable to the hood release handle.
    Fig 1: Hood Release Handle & Cable
    GM182641Courtesy of GENERAL MOTORS CORP.
  2. Install the hood release handle to the instrument panel.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 2: Hood Release Handle Base
    GM182644Courtesy of GENERAL MOTORS CORP.
  3. Install the bolts to hood release handle base.

    Tighten:  Tighten the hood release handle bolts to 2 N.m (18 lb in).

  4. Install the left instrument panel insulator. Refer to Closeout/Insulator Panel Replacement - Left in Instrument Panel, Gages, and Console.
scientia non olet · About Mike's Workshop Manuals