Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2004 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 204 (Seat System) >> Repair Instructions >> Seat Adjuster Replacement - Front >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the adjuster on the seat frame.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the adjuster bolts.

    Tighten:  Tighten the bolts to 24 N.m (18 lb ft).

    3. Fig 1: Installing Adjuster Bolts
    GM800752Courtesy of GENERAL MOTORS CORP.
  3. Return the seat pad and the trim to the installed position.
  4. Install the trim cover J-hooks.
  5. Install the electrical harness clip and the retainer on the adjuster bracket.
    6. Fig 2: Installing Electrical Harness Clip & Retainer
    GM800745Courtesy of GENERAL MOTORS CORP.
  6. Connect the electrical harness to the seat motor harness.
    7. Fig 3: Connecting Electrical Harness To Power Seat Motor Harness
    GM800742Courtesy of GENERAL MOTORS CORP.
  7. Install the seat belt buckle. Refer to Seat Belt Buckle Replacement - Left Front in Seat Belts.
  8. Install the seat belt bracket (2).
    9. Fig 4: Installing Seat Belt Bracket
    GM802619Courtesy of GENERAL MOTORS CORP.
  9. Install the seat trim panel. Refer to Trim Panel Replacement - Front Seat .
    10. IMPORTANT: Inspect the drive cables. Make sure they are straight between the motors and the adjuster.
  10. Install the front seat. Refer to Seat Replacement - Front Bucket .
scientia non olet · About Mike's Workshop Manuals