Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2004 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 199 (Engine Control System 3.4L (Introduction)) >> Repair Instructions >> Crankshaft Position (CKP) Sensor Replacement (24X) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the CKP sensor (1).
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the CKP sensor bolts (4).

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

  3. Install the CKP sensor harness retaining clip (3).
  4. Install the CKP sensor harness retaining clip bolt (4).

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

  5. Connect the CKP sensor electrical connector.
  6. Install the crankshaft balancer. Refer to Crankshaft Balancer Replacement in Engine Mechanical - 3.4L.
  7. Perform the crankshaft variation learn procedure. Refer to CKP System Variation Learn Procedure .
    8. Fig 1: Installing CKP Sensor (24X)
    GM14714Courtesy of GENERAL MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals