Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.

Install the bulb to the license plate lamp socket.
Install the license plate lamp socket, turning clockwise.
Install the license plate lamp to the rear bumper fascia.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the screws to the license plate lamp.
Tighten: Tighten the license plate lamp screws to 2 N.m (18 lb in).

Fig 1: License Plate Lamp (Impala)

Courtesy of GENERAL MOTORS CORP.