Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2004 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 185 (Wiring Systems - Introduction) >> Repair Instructions >> Junction Block Replacement - Accessory Wiring >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
  2. Remove the left instrument panel (I/P) insulator. Refer to Closeout/Insulator Panel Replacement - Left in Instrument Panel, Gages, and Console.
  3. Remove the screws from the accessory wiring junction block.
  4. Adjust the junction block for access.
  5. Remove the circuit breakers (4) and the relays from the junction block as required. Refer to Relay Replacement (Within an Electrical Center)  or Relay Replacement (Attached to Wire Harness) .
  6. If necessary remove the junction block from the bracket assembly.
    7. Fig 1: Junction Block & Components
    GM803447Courtesy of GENERAL MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals