Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2004 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 184 (Battery, Charging System & Starting System) >> Repair Instructions >> Generator Brace Replacement (3.8L) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the generator rear brace (4).
  2. Install the generator rear brace bolt (3).
  3. Install the generator rear brace nut (5).
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Tighten the generator bolt and nut in the following sequence:

    Tighten: 

    1. Tighten the generator rear brace bolt (3) to 50 N.m (37 lb ft).
    2. Tighten the generator rear brace nut (5) to 50 N.m (37 lb ft).

    5. Fig 1: Installing Generator Rear Brace (3.8L)
    GM461838Courtesy of GENERAL MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals