Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2004 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 184 (Battery, Charging System & Starting System) >> Repair Instructions >> Battery Negative Cable Disconnect/Connect Procedure >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
    IMPORTANT: Clean any existing oxidation from the contact face of the battery terminal and battery cable using a wire brush before installing the battery cable to the battery terminal.
  1. Connect the negative battery cable to the battery.

    Tighten:  Tighten the terminal bolt to 15 N.m (11 lb ft).

    2. Fig 1: Connecting Negative Battery Cable
    GM513056Courtesy of GENERAL MOTORS CORP.
  2. Set the clock and program the radio stations back into the radio as recorded at the beginning of the procedure. Refer to Radio/Audio System Description and Operation in Entertainment.
scientia non olet · About Mike's Workshop Manuals