Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2004 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 167 (Front Drive Axle) >> Repair Instructions >> Lubricant Replacement - Front Drive Axle >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Drain Plug & Washer
    GM748021Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the drain plug and the washer.

    Tighten:  Tighten the drain plug to 32 N.m (24 lb ft).

  2. Fill the differential carrier assembly with lubricant. Use the proper fluid. Refer to Capacities - Approximate Fluid and Fluid and Lubricant Recommendations in Maintenance and Lubrication.
    3. Fig 2: Front Axle Fill Plug
    GM748025Courtesy of GENERAL MOTORS CORP.
  3. Install the fill plug.

    Tighten:  Tighten the fill plug to 32 N.m (24 lb ft).

  4. Install the engine protection shield. Refer to Engine Protection Shield Replacement in Frame and Underbody.
  5. Lower the vehicle.
scientia non olet · About Mike's Workshop Manuals