Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2004 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 134 (Wiper System & Washer System) >> Repair Instructions >> Wiper Motor Cover Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Wiper Motor Cover
    GM751559Courtesy of GENERAL MOTORS CORP.
  1. Install the wiper cover and module to the wiper motor.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the 3 screws retaining the wiper motor cover to the wiper motor.

    Tighten:  Tighten the 3 wiper motor cover screws to 3 N.m (27 lb in).

  3. Install the wiper transmission assembly to the vehicle. Refer to Wiper Transmission Replacement .
scientia non olet · About Mike's Workshop Manuals