Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2004 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 120 (Engine Control System - 4.8L, 5.3L, & 6.0L - Introduction) >> Repair Instructions >> Fuel Hose/Pipes Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 Chevrolet TrailBlazer, and 2004 Buick Rainier. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating EVAP Components
    GM887437Courtesy of GENERAL MOTORS CORP.
  1. Install the fuel lines.
  2. Engage the fuel lines to the clip (7) at the front of the fuel tank.
  3. Remove the caps from the fuel sender assembly pipes.
  4. Connect the fuel feed line to the fuel filter. Refer to Quick Connect Fitting(s) Service (Plastic Collar) .
  5. Connect the fuel return line to the sender assembly. Refer to Quick Connect Fitting(s) Service (Plastic Collar) .
  6. Install the fuel tank. Refer to Fuel Tank Replacement .
scientia non olet · About Mike's Workshop Manuals