Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2004 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 120 (Engine Control System - 4.8L, 5.3L, & 6.0L - Introduction) >> Repair Instructions >> Camshaft Position (CMP) Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 Chevrolet TrailBlazer, and 2004 Buick Rainier. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Camshaft Position (CMP) Sensor & Bolt
    GM260128Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Clean the are around the camshaft position (CMP) sensor before removal in order to prevent debris from entering the engine.
  1. Remove the intake manifold. Refer to Intake Manifold Replacement in Engine Mechanical - 4.8L, 5.3L, and 6.0L.
  2. Remove the CMP sensor bolt.
  3. Remove the CMP sensor.
scientia non olet · About Mike's Workshop Manuals