Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2004 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 119 (Engine Control System - 4.2L (Introduction)) >> Repair Instructions >> Secondary Air Injection (AIR) Pump Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing AIR Pump
    GM1297873Courtesy of GENERAL MOTORS CORP.
  1. Install the AIR pump to the vehicle.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the 3 bolts securing the AIR pump bracket to the vehicle frame.

    Tighten:  Tighten the bolts to 20 N.m (15 lb ft).

  3. Connect the electrical connector to the AIR pump.
  4. Install the electrical relay to the AIR pump bracket.
    5. IMPORTANT: Ensure the air inlet and air outlet pipes are clean and clear of any debris before connecting to the AIR pump.
  5. Connect both the air inlet and air outlet pipe to the AIR pump.
  6. Lower the vehicle.
scientia non olet · About Mike's Workshop Manuals