Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2004 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 119 (Engine Control System - 4.2L (Introduction)) >> Repair Instructions >> Air Cleaner Resonator Outlet Duct Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. If the IAT sensor was previously removed, install the IAT sensor into the air cleaner outlet duct. Refer to Intake Air Temperature (IAT) Sensor Replacement .
    2. Fig 1: Top Of Engine View
    GM732051Courtesy of GENERAL MOTORS CORP.
  2. Install the air cleaner outlet duct onto the air cleaner outlet resonator (3).
  3. Install the air cleaner element. Refer to Air Cleaner Element Replacement .
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Properly position the air cleaner outlet duct clamp (2) on the air cleaner side of the air cleaner outlet resonator (3).

    Tighten:  Tighten the clamp (2) to 4 N.m (35 lb in).

  5. Connect the electrical connector to the IAT sensor (1).
scientia non olet · About Mike's Workshop Manuals