Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2004 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 110 (Lighting Systems) >> Repair Instructions >> Tail Lamp Circuit Board Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the tail lamp. Refer to Tail Lamp Replacement .
    2. Fig 1: Removing/Installing Tail Lamp Circuit Board
    GM732917Courtesy of GENERAL MOTORS CORP.
  2. Remove the 2 tail lamp circuit board retaining screws.
  3. Simultaneously release the bottom 4 locking tabs and partially remove the tail lamp circuit board.
  4. Release the top 2 locking tabs and remove the tail lamp circuit board from the tail lamp assembly.
  5. Remove the bulbs from the tail lamp circuit board.
scientia non olet · About Mike's Workshop Manuals