Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2004 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 110 (Lighting Systems) >> Repair Instructions >> Hazard and Turn Signal Flasher Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Accessing Hazard & Turn Signal Flasher
    GM763321Courtesy of GENERAL MOTORS CORP.
  1. Position the flasher to the insulator panel.
  2. Connect the electrical connector to the flasher.
  3. Install the flasher retaining bracket to the insulator panel.
  4. Install the left closeout/insulator panel. Refer to Closeout/Insulator Panel Replacement - Left in Instrument Panel, Gages and Console.
scientia non olet · About Mike's Workshop Manuals