Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2004 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 110 (Lighting Systems) >> Diagnostic Information and Procedures >> Memory/Heated Seat Switch Backlighting Inoperative

Memory/Heated Seat Switch Backlighting Inoperative

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
Memory/Heated Seat Switch Backlighting Inoperative Diagnostic Test

Step Action Yes No
Schematic Reference:  Interior Lights Dimming Schematics  
Connector End View Reference:  Lighting Systems Connector End Views  ,  Body Control System Connector End Views  in Body Control System, or Power Door Systems Connector End Views in Doors
1 Did you perform the Lighting Systems Diagnostic System Check? Go to Step 2  Go to Diagnostic System Check - Lighting Systems 
2 Verify that the memory/heated switch backlighting is inoperative.
Does the memory/heated switch backlighting operate normally?
Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems Go to Step 3 
3 Are any other dimmable interior backlighting lamps inoperative? Go to Interior Backlighting Inoperative  Go to Step 4 
4
  1. Place the headlamp switch in the PARK position.
  2. Adjust the IP dimmer switch to the full intensity position.
  3. Test for an open, high resistance, or short to voltage in the memory/heated seat switch illumination control circuit. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.
Did you find and correct a condition?
Go to Step 10  Go to Step 5 
5 Use a test lamp connected to B+ to backprobe the memory/heated seat switch illumination control circuit terminal at the driver door module (DDM) connector.
Does the test lamp illuminate?
Go to Step 7  Go to Step 6 
6 Inspect for poor connections at the harness connector of the DDM. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.
Did you find and correct the condition?
Go to Step 10  Go to Step 8 
7 Inspect for poor connections at the harness connector of the memory/heated seat switch. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.
Did you find and correct the condition?
Go to Step 10  Go to Step 9 
8
IMPORTANT: Perform the setup procedure for the DDM.
Replace the DDM. Refer to Switch Replacement - Door Lock and Side Window - Driver in Doors.Did you complete the replacement?
Go to Step 10  -
9 Replace the memory/heated seat switch. Refer to Memory Seat Switch Replacement in Seats.
Did you complete the replacement?
Go to Step 10  -
10 Operate the system in order to verify the repair.
Did you correct the condition?
System OK Go to Step 3