Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2004 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 108 (Stationary Window System) >> Repair Instructions >> Windshield Side Reveal Molding Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the windshield side reveal molding under the outer edges of the air inlet grille panel.
    2. Fig 1: View Of Front Door Sealing Weatherstrip
    GM441415Courtesy of GENERAL MOTORS CORP.
  2. Position the windshield side reveal molding (2) to the windshield pillar.
    3. Fig 2: Identifying Windshield Reveal Molding Screws
    GM301107Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the screws to the side reveal molding.

    Tighten:  Tighten the screws to the side reveal molding to 2 N.m (18 lb in).

  4. Reposition the front door weatherstrip to the pinch-weld flange.
    5. Fig 3: Removing/Installing Weather-Strip Retainers
    GM588275Courtesy of GENERAL MOTORS CORP.
  5. Install the push-pin retainers (2) to the front door sealing weatherstrip located at the base of the pillar.
  6. Close the door.
scientia non olet · About Mike's Workshop Manuals