Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2004 >> Aztek Base, AWD >> Repair and Diagnosis >> Body & Frame >> Seats >> Seat System >> Repair Instructions >> Seat Back Replacement - Rear (Split Bench) >> Installation Procedure

Installation Procedure

    Fig 1: Locating Rear Seat Back Pivot Stud
    GM629140Courtesy of GENERAL MOTORS CORP.
  1. Place the rear seat back pivot stud to the rear seat pivot point.
  2. Install the seat back to the pivot point. Press the seat back into the socket until fully seated.
    3. Fig 2: Identifying Seat Back Recliner Hinge Upper Bolts
    GM629131Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the bolts to the seat back recliner hinges.

    Tighten:  Tighten the bolts to 40 N.m (30 lb ft).

    4. Fig 3: Locating Rear Center J-Hook Retainers
    GM629179Courtesy of GENERAL MOTORS CORP.
  4. Install the lower J-hook retainer.
  5. Install the trim panel to the seat back. Refer to Trim Panel Replacement - Rear Seat Back .
  6. Install the outer trim panel to the seat cushion. Refer to Seat Cushion Outer Trim Panel Replacement - Rear Seat (Bucket)  or Seat Cushion Outer Trim Panel Replacement - Rear Seat (Split Bench) .
  7. Inspect the seat back for proper operation.
  8. Install the split bench seat. Refer to Seat Replacement - Rear 50-50 Split .
scientia non olet · About Mike's Workshop Manuals