Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2003 >> Grand Prix GTP >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Wiper/Washer Systems >> Wiper System And Washer System >> Repair Instructions >> Wiper Drive System Module Replacement >> Installation Procedure

Installation Procedure

  1. Position the wiper drive system module to the vehicle.
  2. Connect the wiper motor electrical connector.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install the wiper drive system screws.

    Tighten 

    Tighten the screws to 10 N.m (89 lb in).

  4. Using the J 39529  , Install the wiper transmission to the wiper motor crank arm.
  5. Install the wiper motor water deflector. Refer to WIPER MOTOR WATER DEFLECTOR REPLACEMENT  .
  6. Install the air inlet grille panel. Refer to AIR INLET GRILLE PANEL REPLACEMENT in Body Front End.
  7. Inspect the wipers for proper operation.
    Fig 1: Positioning Wiper Drive System Module To Vehicle
    G01503356Courtesy of GENERAL MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals