Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2003 >> Aztek AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 320 (Wheel Alignment Specifications & Adjustment Procedures) >> Repair Instructions >> Front Camber Adjustment >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the strut to the vehicle. Refer to STRUT, STRUT COMPONENT AND/OR SPRING REPLACEMENT .

    Tighten: 

    Tighten the strut-to-knuckle bolts as far as to allow movement of the knuckle 

  2. Install the tire and wheel assemblies. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION .
  3. Adjust the camber (1).

    Tighten: 

    Tighten the strut-to-knuckle bolts to 122 N.m (90 ft lbs) 

    Fig 1: Adjusting The Camber
    G01720497Courtesy of GENERAL MOTORS CORP.
  4. Lower the vehicle.
scientia non olet · About Mike's Workshop Manuals