Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2002 >> Aztek AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1617 (Engine Controls And Fuel - 3.5L - Introduction) >> Repair Instructions >> Manifold Absolute Pressure Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of MAP Sensor Seal & Upper Intake Manifold
    GM1608814Courtesy of GENERAL MOTORS CORP.
  1. Install the MAP sensor seal into the upper intake manifold.
  2. Install the MAP sensor and bracket.
    3. CAUTION: Refer to Fastener Caution .
  3. Install the upper intake manifold bolts.

    Tighten:  Tighten the bolts to 25 N.m (18 lb ft).

    4. Fig 2: View Of MAP Sensor Electrical Connector
    GM1608869Courtesy of GENERAL MOTORS CORP.
  4. Install the spark plug wire clip to the intake manifold bracket.
  5. Connect the MAP sensor electrical connector (1).
  6. Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
scientia non olet · About Mike's Workshop Manuals