Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2002 >> Aztek AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1355 (Antilock Brake System) >> Repair Instructions >> Wheel Speed Sensor Replacement - Rear >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Buick Regal and 2003 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: The rear wheel speed sensors and rings are integral with the hub and bearing assemblies.

If a speed sensor or a ring needs replacement, replace the entire hub and bearing assembly. Refer to Wheel Bearing/Hub Replacement - Rear (Disc Brakes) or Wheel Bearing/Hub Replacement - Rear (Drum Brakes) in Rear.

  1. Raise and support the vehicle on a suitable hoist. Refer to LIFTING AND JACKING THE VEHICLE in General Information.
  2. Remove the rear tire and wheel assembly. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION in Tires and Wheels.
  3. Disconnect the electrical connector from the rear wheel speed sensor.
    Fig 1: Disconnecting Electrical Connector From Rear Wheel Speed Sensor
    G01569904Courtesy of GENERAL MOTORS CORP.
  4. Remove the hub and bearing assembly (1). Refer to Wheel Bearing/Hub Replacement - Rear (Disc Brakes) or Wheel Bearing/Hub Replacement - Rear (Drum Brakes) in Rear.
    Fig 2: View Of Hub And Bearing Assembly
    G01569905Courtesy of GENERAL MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals