Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2001 >> Aztek Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 143 (Engine Controls - Removal, Overhaul & Installation) >> Ignition Systems >> Electronic Ignition Module >> Removal & Installation (2.2L)

Removal & Installation (2.2L)

WARNING: This page is about a different car, the 2002 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn OFF the ignition. Disconnect Intake Air Temperature (IAT) sensor harness connector. The IAT sensor is mounted in the air intake duct. Loosen clamp at air cleaner assembly. Remove push-pin attachment from outlet resonator/duct assembly-to-support bracket.
  2. Loosen clamp at throttle body assembly. Disconnect PCV fresh air hose at cam cover. Remove outlet resonator/duct assembly. Disconnect the EI module harness connector. See Figure . Remove attachment screws from the EI module. Remove the EI module. To install, reverse removal procedure.
scientia non olet · About Mike's Workshop Manuals