Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2001 >> Aztek Base, AWD >> Repair and Diagnosis >> General Information >> Computer Relearn Procedures >> General Motors (Trucks & Vans) >> MONTANA, Silhouette & Venture >> PASS-Key® III System Quick Learn Procedure

PASS-Key® III System Quick Learn Procedure

NOTE: PASS-Key® III system quick learn procedure is used to learn additional ignition keys. A learned key must be used to initiate procedure. Up to 10 ignition keys can be learned.
  1. Insert a valid ignition key in ignition switch. Turn ignition switch to ON position. After 2 second bulb test, turn ignition off and remove key.
  2. Within 10 seconds, insert new valid mechanical code unlearned key and turn ignition switch to RUN position. Security light will illuminate until key is learned. This may happen so quickly light illumination is not observed. Turn ignition switch to OFF position. Remove ignition key 10 seconds after light goes out.
  3. To learn additional keys, repeat step  2. To exit procedure, turn ignition off for more than 10 seconds.
scientia non olet · About Mike's Workshop Manuals