Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2001 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 776 (Power Steering System) >> Repair Instructions >> Power Steering Pump Flow Control Valve Actuator Replacement - On Vehicle >> Assembly Procedure

Assembly Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Important:  Note the orientation of the variable assist steering actuator discharge fitting.

  1. Lubricate and install the new O-ring seal with power steering fluid.
    CAUTION: Refer to FASTENER NOTICE .
  2. Install the variable assist steering actuator (1) to the pump assembly.

    Tighten 

    Tighten the actuator to 62 N.m (46 lb ft).

  3. Install the negative battery cable.

    Important:  If a new variable assist steering actuator (1) is being installed, position the electrical connector before installing the retaining ring (2).

  4. Install the electrical connector to the variable assist steering actuator (1).
  5. Install the retaining ring (2) to the variable assist steering actuator (1).
    Fig 1: Installing Variable Assist Steering Actuator
    G01662157Courtesy of GENERAL MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals