Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2001 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 697 (Door System, Mirror System & Window System) >> Repair Instructions >> Module Replacement - Rear Power Window (Tahoe/Yukon/Escalade) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Rear Power Window Module (Tahoe/Yukon/Escalade)
    GM581720Courtesy of GENERAL MOTORS CORP.
  1. Install the module to the door.
    2. NOTE: Refer to FASTENER NOTICE .
  2. Install the bolts retaining the regulator to the door.

    Tighten:  Tighten the bolts to 9 N.m (7 lb ft).

  3. Align the window to the regulator, and tighten the clamp bolts.

    Tighten:  Tighten the clamp bolts to 9 N.m (7 lb ft).

  4. Connect the window motor electrical connector.
  5. Install the water deflector. Refer to Water Deflector Replacement - Rear Door (Tahoe/Yukon/Escalade)  or Water Deflector Replacement - Rear Door (Suburban/Yukon XL/Avalanche/Escld EXT) .
  6. Install the trim panel. Refer to Trim Panel Replacement - Side Rear Door (Tahoe/Yukon/Escalade)  or Trim Panel Replacement - Side Rear Door (Suburban/Yukon XL/Avalanche/Escld EXT) .
scientia non olet · About Mike's Workshop Manuals