Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2001 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 604 (Power Steering System) >> Repair Instructions >> Power Steering Gear Replacement (Non-Rack & Pinion) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the steering gear to the frame and install the retaining bolts. Tighten the bolts to 150 N.m (110 ft lbs)
  2. Install the pitman arm. Refer to PITMAN ARM REPLACEMENT (RWD) or PITMAN ARM REPLACEMENT (4WD) .
  3. Install the engine protection shield, if equipped.
  4. Remove the safety stands.
  5. Lower the vehicle.
  6. Install the intermediate shaft to the steering gear. Refer to INTERMEDIATE STEERING SHAFT REPLACEMENT - LOWER .
  7. Remove the caps or plugs from the steering gear and hoses.
  8. Install the hoses to the steering gear. Tighten the hoses fitting to 28 N.m (20 ft lbs).
  9. Bleed the power steering system. Refer to Bleeding Power Steering System .
scientia non olet · About Mike's Workshop Manuals